Beyonwiz DP-P2 Bedienungsanleitung PDF herunterladen (Seite 8)

So the caps are installed correctly… the diodes are around the right way… all the obvious dry joints have been

resoldered nicely… NO SHORTING (double check that too)… Basically you’re itching to get it back into the

machine right??? Ok, go for it, that’s pretty much the repair done!

Perhaps just one final check…All good? (Yes I’m Paranoid…)

Ok, time to reinstall so keep reading.

-------------------------------------------------------------------------------------------------------------------------------------

SECTION 7 – REASSEMBLING YOUR BEYONWIZ

To RE-ASSEMBLE your PSU unit into your Beyonwiz…

1. Place the PSU back into its proper home, make sure the cables are not caught underneath, line it up so that

the FOUR (4) screw holes are aligned to the case mounts, then replace the screws you took out and secure the

PSU.

2. Connect the Hard drive power cable back into the HDD.

3. Reconnect the BW mainboard power cable to the mainboard. Line it up and push down, it should click into

place and will not fit on properly the wrong way around.

5. Check to make sure the SATA cable is still pushed in tight in both the hard drive & mainboard, sometimes

it can work loose.

6. Reconnect the mains power cable to the PSU. Line it up and push down, it should click into place.

That’s it. You’re basically ready to go. Do not replace the lid just yet, do some testing first.

-------------------------------------------------------------------------------------------------------------------------------------

SECTION 8 – TESTING AND FINAL NOTES

Before replacing the lid and installing your unit back into its permanent home, test it for power and function.

A basic test would be to turn it on and check for standby power. At this point power the wiz up and check that

the unit goes from standby to “on”, and then check that the HDD powers up, and that you have output to a

TV/monitor. If that’s all good, then you can do further functionality tests whenever you are ready. Depending

on how bad your PSU was, you may well need to format your Hard Drive, this is quite normal, and at the very

least you may need to do a HDD Check, this does not mean your PSU is still faulty.

There is also every possibility you MAY need to REPLACE the SATA cable as well and there is no time like

now to do it being that the wiz is open. They tend to fail a fair bit.

Ok, Now that you have… completed your testing, are happy with the result and all features are working well -

you can relax, put the lid back on and replace the 6 case screws, job done! The cost apparently of replacing

this PSU with a new one from Beyonwiz was upwards of $150+ excluding delivery or labour to fit it (not sure

of the current price if they are even available that is). This repair should cost you no more than $25 - $30 in

components plus maybe a bit for delivery if you order them online and of course the cost of your time too!

To anyone that would like me to do it for them, I can do… for a very low and reasonable amount, which varies

on how bad your PSU is, as it takes a LONG TIME to repair these units properly. (See revision history below

for ways to contact me). I do not repair these for the money / profit as anyone who has used me would know.

I hope this assists many users with extending the life of their units!

-------------------------------------------------------------------------------------------------------------------------------------

1 2 3 4 5 6 7 8 9

Keine Kommentare

Beyonwiz DP-P2 Bedienungsanleitung Seite 8